How to use

The Touch Up Pen

If you want to use the brush, fully unscrew the clear cap.

If you want to use the needle, tear off the clear cap.

Press the bottom part of the touch up pen until the paint starts penetrating through the needle tip.

Make sure NOT to press the needle!

Once used, keep the touch up pen in a dark place and make sure the clear cap is tightly closed.

The primer

It is recommended to use Rust stop, modifier / primer when factory primer is damaged or uncovered metal is visible, particularly where there are signs of corrosion.

Before using Rust stop the surface should be properly prepared. If there is a substantial layer of corrosion damage, it should be removed mechanically. If there is some flaking paint on the edges of a damaged area, remove it too. The surface should be dry, clean and grease-free.

Before every use of Rust stop, shake the touch up pen thoroughly. Apply Rust stop and leave it to dry. When the surface is no longer sticky, paint may be applied. The drying time depends on the ambient temperature.

Rust stop is water-based, so any excess amount or smears can be cleaned off with water before it dries. When it has dried, it can only be removed with a nitro diluent or acetone.

The paint

Shake the touch up pen thoroughly before using the paint. Make sure that the damaged areas are dry, clean and grease-free. Where there is some flaking paint on the edges of a damaged area, remove it, too. Apply the paint in layers. Apply the next layer only after the previous layer has dried. The number of layers required depends on the paint coverage area. Painted surfaces are recommended to be topped with a clear coat. Surface not topped with a clear coat becomes less resistant to environmental impact.

The clear coat

Before the using the clear coat make sure NOT to shake the touch up pen because air bubbles formed in it will prevent even distribution of the clear coat on the surface. Apply the clear coat in layers. Apply the next layer only after the previous layer has dried. After the application of the clear coat, the surface will be shiny and resistant to environmental impacts.